oil condenser

英 [ɔɪl kənˈdensə(r)] 美 [ɔɪl kənˈdensər]

油浸电容(器)

电力



双语例句

  1. Let the oil vapor pass through a condenser.
    让油蒸汽通过一个冷凝器。
  2. The refrigerant, refrigeration oil and an evaporator, condenser and piping in the drying process is very important.
    对冷媒,冷冻油及蒸发器、冷凝器和配管的干燥处理是极为重要的。
  3. Design of a Ventilated Oil Steam Semiconductor Condenser for a Fuel Tank
    油箱油蒸汽半导体冷凝通气器的设计
  4. For example, one fabricator installed an oil trap in the line between the vacuum pump and chamber in a lyophilizer with an internal condenser.
    例如有的制造商在真空泵和前箱间安装了有内部冷凝器的捕油器。
  5. Solving higher oil content in liquid oxygen in the main condenser of an air separation unit
    空分设备主冷液氧中油含量高的处理
  6. Analysis on accident cause of hot oil condenser
    热油冷凝器事故原因分析
  7. The causes of higher oil content in liquid oxygen in the main condenser are presented and the effect of cooling water quality on safety operation of an air separation unit is analyzed.
    介绍了空分设备主冷液氧中油冷量高的原因和处理方法,同时分析了冷却水水质对空分设备安全运行的影响。
  8. This paper briefly analyzes the fault examples of oil condenser bushing for transformer, and presents some suggestions, which can be the reference of improving measures for related sectors and departments.
    本文针对变压器上大量使用的油漫电容式套管发生的故障实例,进行简要的归纳分析,并提出一些建议,可作为相关部门采取改进措施的参考。
  9. The Effect of Lubricating Oil on Heat Transfer and Pressure Drop of Air Condenser
    润滑油对风冷冷凝器管内换热和阻力影响的分析
  10. Investigation on heat transfer performance of oil condenser with lozenge fin tubes supported by rings
    空心环支承菱形翅片管油冷凝器传热性能
  11. Fault Analyses of Oil Condenser Bushing for Transformer
    变压器用电容型套管故障简析
  12. In the L8 ( 2 7) orthogonal test, six factors considered were as follows: lubricating oil, condenser thickness, fan diameter, angle of fan vane, frequency of fan electromotor and environment temperature.
    通过L8(27)正交试验,对压缩机所用润滑油的种类、冷却器的散热面积和厚度、风扇直径、扇叶角度、风扇电机频率以及环境温度6个因素进行了正交试验研究。